Lasercutting and 3D printing in the Barber Shop

3d printing 

1. Click on Prusa Slicer

2. Pull out the SD card, plug it into the Vanja “Thumb Drive” and plug that into the computer

3. Click on Add.

4. Find your .STL file in the 00001BARBERTECHNOLOGYFOLDER without typing (the list SHOULD be in ABC order … double click or click and open.

5. Click Slice Now in the Bottom Right corner.

6. Click Export GCODE in the Bottom Right corner.

7. Find “USB Drive” on the left side to save it in. (Save)

8. Click the Eject Button (NOT THE X).

9. Remove the Vanja and SD Card and put them back where you got them (Vanja Thumb Drive goes back in the Orange Tray & SD Card goes back in the Prusa- MAKE SURE THE METAL IS FACING YOU.

10. Turn the knob clockwise until it points > to your file and then poke it in quickly like a button. DO NOT HOLD IT IN TOO LONG.

Lasercutting

PROTOTYPES ON CARDBOARD MUST BE APPROVED BEFORE YOU CAN LASERCUT FINAL PRODUCTS ON BIRCH

1. Open your Adobe Illustrator Project. After the previous lasercut is done, click File & Print.

2. On the Print Window, click Print.

3. Click on the red lasercutter icon (next to Adobe Illustrator on the taskbar).

4. If all your lines are bright red and blue, you are ready to move your design. If it is light & gray, STOP! Click on the button with 4 arrows. Some squares will appear. Drag the squares to move your design around. Take care not to miss and accidentally ZOOM in.

5. The “Focus View” button to the left of “arrows button” will put a red laser pointer dot on the material. Click on all the edges and corners to make sure your design will fit on your material (the top has to be open for the red dot to appear).

6. Once you are sure it will fit, click on the magnifying glass button to change the red “Go” button to “Settings”.

Cardboard Click on the Manual Control Tab: MAKE SURE TO CLICK “APPLY” AFTER EACH ROW	BIRCH, go to Materials Database, then click on + next to Natural + next to Wood + next to Hard Wood Then click on the actual words General Hard Woods Set the thickness to ____ (Calipers???) AFTER YOU HAVE RUN IT ONCE, IT MIGHT NOT HAVE CUT THROUGH!! You might need to run red only again!
Color Mode Power Speed PPI Black Skip doesn’t matter, just click Apply Blue Rast/Vect 100% 40% 500 Red Rast/Vect 100% 12% 300	7. BASSWOOD, go to Materials Database, then click on + next to Natural + next to Wood + next to Soft Wood Then click on the actual words General Soft Woods Set the thickness to ____ (Calipers???) AFTER YOU HAVE RUN IT ONCE, IT MIGHT NOT HAVE CUT THROUGH!! You might need to run red only again!

You’re ready to lasercut!

8. Shut the lasercutter, and DON’T LET IT SLAM!! 

9. Turn on the fan, by flipping the light switch on the outlet behind the lasercutter. 

10. Click the big, green play button to start it. 

11. Monitor it closely to make sure it doesn’t catch on fire. If it DOES catch on fire … yell, scream, and freak out until Mr. B comes running over. 

12. After the duh-duh noise from previous cuts, the next person can click File >> Print as you can cut off the fan and retrieve your lasercut!!

FIRE??? If it DOES catch on fire … yell, scream, and freak out until Mr. B comes running over. Post-fire, we open the garage door and point every fan OUT. Leave the exhaust fan on, even though we won’t lasercut for a bit!