Lasercutting a 3D Snowflake
or for a REAL CHALLENGE (this will take longer and be more work!):
Laser-cutting a Cell Phone Stand
- Cell Phone Stand Video 1- Base File Setup
- Call it "Username Cell Stand Back"
- 12x12” workspace size
- Change to RGB
- Cell Phone Stand Video 2- Setting Up your Back Piece
- Open "Username Cell Stand Back"
- Increase the size of the bottom hole to put in the cords
- 7” tall, 4” wide
- Cell Phone Stand Video 3- Bottom Piece
- Call it "Username Cell Stand Base"
- You will need to add an Engraved Decoration, could be copied and pasted from your earlier work ...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.